Denon ADV-1000 Operating Instructions Manual page 36

start playback on the selected component.
• For operating instructions, refer to the component's
manual.
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume
- r _- / The volume level is displayed
MASTER VOLUME __
Main unit Remote contr@ unit
• The volume can be adjusted within the range -60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB
Input mode when playing DTS sources
• If DTS-compatible CDs are played in the "PCM" mode, noise is
output because DTS playback is not possible.
To play a DTS-compatibb source, be sure to set the input mode
to "AUTO" or "DTS'.
• Noise may be generated at the beginning of playback end while
searching during DTS playback in the AUTO mode If so, play in
the DTS mode.
• To check the currently playing program source, etc.
Press the STATUS button.
FUNCTION
STATUS
Main unit Main unit Remote control unit
To perform this operation on the main unit, press the
STATUS button, then turn the FUNCTION/SELECT knob.
The current program source and surround settings are shown
on the display each time the button is pressed. (When the
function is set to DVD, the information is also displayed on the
TV screen.)
Input mode display
• in the AUTO mode
• in the DIGITAL PCM mode
• in the DIGITAL DTS mode
the ;nputsignal
-DG-A ) _ !IS
I i -. I /
- DIG -A
OTS
• in the ANALOG mode
- ANA -
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
_DIG- BI:]PROLOGIC _[
rI1DIGITAL _.Q
-_DG PC_ _ I _ lights, d ependng
"""" on the input
/ _AI _ signat
C DIG_-
• "DIG" lights when digital signals are input properly. If "DIG" _s
flashing, check whether the connections are proper and whether
the input component's power is on.
Input mode when playing CD sources
• When playing CDs containing recordings of live concerts, etc., in
the "AUTO" mode, the sound may be slightly broken at the
beginning if this happens, switch to the "PCM" mode.
36