Denon ADV-1000 Operating Instructions Manual page 53

Example: Presetting FM station (currently tuned in) at preset number P03
, gggl
2oo£1
©O0Ol
Before operating the remote control unit!
TjNE[T,N_
Be sureto pressthe properremote control mode selector _'_
buttonto setthe remote control unitto the AV mode.
While the "PO -" ("PI-", "P2-" or "P3-") indication is flashing,
use the shift button and the channel (CH) buttons (-, +) to
dsplay the preset number "P03"
,_ Each press of the shift button adds 10 to the current preset
number in the range of P01 to P40.
Example:
Starting with a Pt3
setting, each press of
the shift button results
in the changes P13 ..... "-_
P23 P33 _ P03 Remote control unit
P13
Example:
Starting with a PO0 setting, each press of the shift button results in
the changes P0-P1O P20 P30 P40 P10 ..
1
Tune in the broadcast station that is to be preset and press
the Memory button.
• A "PO -" ("Ply', "P2-" or "P3-") indication flashes for 10
seconds.
Press the MEMORY button while the "P03" display _s
flashing
• The "P03" display will light and presetting will be
completed
NTSC/PAL NTSCJPAL
Remote control unit Remote control unit
Presetting
• Up to 40 AM or FM stations can be preset using this procedure.
• In addition to the reception frequency, the reception mode {monaural or auto) is also preset, so check the display when presetting stations.
• If a station is preset at a number where a station is already preset, the previous station is replaced with the new station.
• The preset memory is not cleared when the power cord is unplugged.
Example: Listening to the station preset at number P03 (This operation is only possible from the remote control unit.)
_m
®®,.@,o
0000
0000
©oo©
Before operating the remote control unit!
TJNE_T£4_
Be sure to press the proper remote control mode selector (_
button to set the remote control unit to the AV mode.
1
Press the remote control shift button and the channel (CH)
button (-, +) and select preset number "P03"
Remote control unit
53