Denon ADV-1000 Operating Instructions Manual page 72

• The included remote control unit can be used to turn the power to the standby mode after a maximum of 120 minutes. {Sleep timer)
• Use this function to automatically switch the power to the standby mode after a specific amount of time {minutes).
Example: To set the power to the standby mode in 50 minutesaccording to the clock. Be sure to correct the current time setting.
1
2
Select and play the desired function.
Press the SLEEP button.
• "120" is displayed and the "SLEEP" indicator flashes.
S_EEp
SLEEP
Remote control unit
The display switches as follows each time the SLEEP
button is pressed:
_,.- 120 _,.-90 _,.- 60 _,.- 50 _,.- 40 _,.- 30 _,.- 20 _,.- 10 _
"SLEEP" indicator off q
When the "SLEEP" indicator is flashing, press the SLEEP
button again until "50" is displayed.
• "50" is displayed and the "SLEEP" indicator flashes
S_EEp
........ j
SLEEP
NOTES:
• If the SLEEP button is pressed while the sleep timer is
operating, the setting returns to 120 minutes. Make the setting
over.
• If the sleep timer and everyday timer settings ovedap, the sleep
timer has priority.
8:00p rn 9:00p m IO:00p m
I I I
I I
ON OFF
I Sleep timer
setting ON OFF
If the timers overlap ike tb}s, the timer operates as follows:
8:00p rn 9:00p m IO:00p m
I I I
ON OFF
Does not operate
• Also, the everyday timer will not operate if its start time is set
within the time during which the sleep timer is operating.
8:00p m
I
I Sleep timer
setting
ON OFF
ON OFF
• The remaining time of the sleep timer can be checked with the
STATUS button.
Remote control unit
• After 4 seconds, the display returns to as it was before the
sleep timer was set, and the "SLEEP" indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
The power is set to the standby mode 50 minutes later
To turn the sleep timer off, press the SLEEP button repeatedly until
the "SLEEP" indicator turns off. The sleep timer can also be
turned off by press the power button on the main unit or the
remote control unit to turn the entire system's power to the
standby mode.
72