Denon ADV-1000 Operating Instructions Manual page 14

• Use speaker cords with twisted wire cores and a diameter of 0.6 to
1.5 mm. Never use cords thicker than 1.5 mm or single-wire cords,
as they may damage the speaker terminals.
• Be sure to interconnect the polarities of the terminals on the
speakers and main unit (0 to _), O to O).
• When making connections, be careful that none of the core wires
of the speaker cords stick out and touch neighboring terminals,
other speaker cords or the rear panel
• Speakers with an impedance of 6 to 16 O/ohms can be connected
for use as center and surround speakers.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
• The protector circuit may be activated if the set is played for long
3eriods of time at high volumes when speakers with an impedance
lower than the specified impedance are connected
Connection the speaker terminals
1. Push the lever. 2 Insert the cord. 3 Return the lever.
Connections
• When making connections, also refer to the operating instructions of the other components
FRONTSPEAKER CENTERSPEAKER SURROUND
SYSTEMS _ SYSTEM SPEAKERSYSTEMS
I SUB WOOFER (NOTE) I
Subwoofer without amplifier
(Super woofer}
Connector iack for
subwooter with built-in
amplifier (super woofer),
L .......................... etc
NOTE: Subwoofer terminal
• When using a subwoofer not including a built-in amplifier,
connect to the "SUBWOOFER" speaker terminal.
• When using a subwoofer including a built-in amplifier, connect to
the "SUBWOOFER" PRE OUT terminal.
• Precautions when connecting speakers
If a speaker is placed near a TV or video monitor, the colors on I
the screen may be disturbed by the speaker's magnetism. If this
shou d happen, move the speaker away to a post on where t
does not have this effect.
14