Denon ADV-1000 Operating Instructions Manual page 63

Use the _. and V cursor buttons to select the MP3
file you want to play, then press the PLAY (1_) button or
ENTER button.
• Playback starts.
-_ The display can be switched between the single
elapsed time and the single remaining time by
pressing the DISPLAY button
-_ Programmed playback is not possible with MP3
discs.
TO change the MP3 file
Press the STOP button, then use the A and V
cursor buttons to reselect the desired MP3 file.
TO set the random play mode
In the stop mode, press the RANDOM button.
Then press the PLAY (1_) button or ENTER button.
TO set the repeat mode
The repeat mode changes each time the REPEAT
button is pressed.
NORMAL -+ TRACK REPEAT _ FOLDER REPEAT
t 1
To return to the initial disc information screen
Press the STOP {m) button, use the _ cursor
button to select "ROOT" at the upper right of the
screen, then press the ENTER button
The screen in step f reappears
Remote control unit
Main unit
Remote control unit
Remote control unit
LI!2_FO[DEII liAME_ j _ M_IC_E { 'lJ
L_ _ _ J _ _ _,_ _ _J
PLAY MODE : _O_MAL
SINGLE ELA_EI) : O0:Ol
NOTES:
• The ADVq000 is compatible with the "MPEGq Audio Layer 3" standards (sampling frequency of 32, 44.1 or 48 kHz). It is not compatible
with such other standards as "MPEG-2 Audio Layer 3", "MPEG 2.5 Audio Layer 3", MP1, MP2, etc.
• It may not be possible to play some CD-R/RW discs due to disc properties, dirt, warping, etc.
• The digital signals output when playing MP3 files are MP3 signals converted into PCM, regardless of whether the audio output presenting
is set to "normal" or "PCM conversion" The signals are output with the same sampling frequency as that of the music source.
• In general, the higher an MP3 file's bit rate, the better the sound quality On the ADV-1000, we recommend using MP3 flies recorded
with bit rates of 128 kbps or greater.
• MP3 files may not be played in the expected order, since the writing software may change the position of the folders and the order of
the files when writing them on the CD-R/RW.
• Manual search and programmed playback are not possible with MP3 discs.
• When writing MP3 files on CD-R/RW discs, select 'qSO9660 level 1" as the writing software format. This may not be possible with some
types of writing software. For details, refer to the writing software's usage instructions.
• With the ADV 1000 it is possible to display folder names and file names on the screen like titles The ADV 1000 can display up to 11
characters, consisting of numbers, capital letters, and the "" {underscore) mark.
• If recorded in a format other than "1SO9660 level 1 ", normal display and playback may not be possible. In addition, folder and file names
including other symbols will not be displayed properly.
• Be sure to add the extension ".MP3" to MP3 files. Files cannot be played if they have any extension other than ".MP3" or if they have
no extension. (with Macintosh computers, MP3 files can be played by adding the extension ".MP3" after the file name consisting of up
to 8 capital or numbers and recording the flies on the CD-R/RW.)
• Do not apply stickers, tape, etc, to either the label side or the signal side of CD R/RW discs. If adhesive gets on the surface of a disc,
the disc may get stuck inside the ADV-1000 and be impossible to eject.
• The ADM1000 is not compatible with packet write software.
• The ADV 1000 is not compatible with lD3-Tag.
• The ADV 1000 is not compatible with play lists
63