Replacing A Disk In A Hot-Swap Storage System - HP StoreVirtual 4000 User Manual

You know which disk needs to be replaced through SAN/iQ monitoring.
When viewed in the Disk Setup tab, the Drive Health column shows Marginal (replace as
soon as possible) or Predictive Failure (replace right away).
RAID is still on, though it may be degraded and a drive is inactive.
Use the instructions in
If RAID is off
If you are unsure which disk to replace
The instructions in the appendix include contacting HP Support for assistance in either identifying
the disk that needs to be replaced or, for replacing more than one disk, the sequence in which
they should be replaced.
To prepare for disk replacement
Preparing for a disk replacement differs according to the RAID level of the storage system and
whether it is a hot-swap storage system. Carefully plan any disk replacement to ensure data safety,
regardless of whether the storage system is hot-swap. The following checklists outline steps to help
ensure data remains safe while replacing a disk.
Identify physical location of storage system and disk
Before beginning the disk replacement process, identify the physical location of both the storage
system in the rack and the disk in the storage system.
Know the name and physical location of the storage system that needs the disk replacement.
Know the physical position of the disk in the storage system. See
(page 37)
Have the replacement disk ready and confirm that it is of the right size and has the right
carrier.
Best practice checklist for single disk replacement in RAID 1, RAID 10, RAID 5, and RAID
6
There are no prerequisites for this case; however, HP recommends that:
All volumes and snapshots show a status of Normal.
Any volumes or snapshots that were being deleted have completed deletion.
One of the following:
◦
RAID status is Normal
◦
If RAID is Rebuilding or Degraded, for storage systems that support hot-swapping of
drives, the Safe to Remove column indicates Yes (the drive can safely be replaced).

Replacing a disk in a hot-swap storage system

The hot-swap storage systems are:
HP P4300 G2 and HP P4500 G2
P4800 G2
HP P4900 G2
HP LeftHand 4130, HP LeftHand 4330, and HP LeftHand 4330fc
Complete the checklist for replacing a disk in RAID 1, RAID 10, RAID 5, or RAID 6. Then follow
the appropriate procedures for the storage system.
"Replacing disks appendix" (page 243)
for diagrams of disk layout in the various storage systems.
for these situations:
"Verifying disk status"
Replacing a disk 43