HP StoreVirtual 4000 User Manual page 252

6. The cache module is attached to the RAID controller and must be removed before removing
the RAID controller. Each cache module is connected to a battery; observe the BBWC status
LED (4, Figure 1 17 (page
If the LED is flashing every two seconds, data is trapped in the cache. Reassemble the
unit, restore system power, and repeat this procedure.
If the LED is not lit, continue with the next step of removing the RAID controller.
Figure 1 17 Battery pack LEDs
7. Disconnect the battery cable from the connector on the rear of the cache module
(page 252)).
Figure 1 18 Disconnect battery cable from the cache module
8. Open the ejector latches on each side of the RAID controller DIMM slot
Normally, the cache module is ejected from the RAID controller DIMM slot. If the module is
not ejected automatically, remove the cache module.
252 Replacing hardware
252)) on both batteries before removing a cache module:
(Figure 1 18
(Figure 1 19 (page 253)).