Then return the storage system to the cluster and migrate the volumes and snapshots back to
the original cluster.
Perform a cluster swap, replacing the storage systems with the worn out SSD drives with
storage systems with new SSD drives. See
cluster swap" (page
NOTE:
If replacing the SSD drives due to the wear life remaining status, the Repair Storage
System feature is not available because there is not a disk failure, indicated by a disk inactive or
disk off event in the Events list.
Verifying disk status
Check the Disk Setup window to determine the status of disks and to take appropriate action on
individual disks when preparing to replace them.
NOTE:
For hardware-specific disk LED or component information for your storage system, see
"Identifying the storage system hardware" (page 21)
Viewing disk status for the VSA
For the VSA, the Disk Setup window shows 1 virtual disk.
Figure 1 1 Viewing the disk status of a VSA
NOTE:
To change the size of the data disk in a VSA, see the HP LeftHand Storage VSA Installation
and Configuration Guide for instructions about recreating the disk in the VI Client.
Viewing disk status for the HP P4500 G2
The disks are labeled 1 through 12 in the Disk Setup window, shown in
correspond to the disk drives from top to bottom, left to right
looking at the front of the HP P4500 G2.
For the HP P4500 G2, the columns Health and Safe to Remove help you assess the health of a
disk and tell you whether or not you can replace it without losing data.
"Changing the cluster—migrating a volume to a different cluster" (page
135).
"Upgrading the storage systems in a cluster using
for document titles and document links.
(Figure 13 (page
159).
Figure 12 (page
38),and
38)), when you are
Managing disks
37