Installing The Raid Controller - HP StoreVirtual 4000 User Manual

Figure 1 19 Removing the cache module
9. Remove the RAID controller from its slot.

Installing the RAID controller

IMPORTANT:
the cache module on the replacement controller board and attach the existing cache module to
the replacement controller board and reconnect the cache module to the battery cable.
1. Slide the RAID controller into the slot, aligning the controller with its matching connector. See
Figure 120 (page 253)
replacing Card 2. Firmly press the controller to seat it properly on the slot.
2. Tighten the screws to secure the RAID controller to the PCI cage (3,
Figure 121 (page
Figure 120 Installing Card 1
The replacement RAID controller contains a new cache module. You must remove
if you are replacing Card 1 and
254)).
Figure 121 (page 254)
Figure 120 (page 253)
Replacing the RAID controller 253
if you are
and