Scanner assembly removals
Flatbed assembly removal
1. Remove the left rear cover. See
2. Remove the RIP/System board cover. See
3. Open the MFP rear cover.
4. Remove the screws (A) securing the upper left and right covers.
A
5. Remove the ADF unit. See
6. Disconnect the CCD ribbon cable, the operator panel cable, and the flatbed motor cable from the
system board.
"Left rear cover removal" on page
"System board removal" on page
"ADF unit removal" on page
4-16.
4-36.
A
4-53.
Repair information
7100-XXX
4-49