High voltage power supply (HVPS) removal
1.Remove the RIP board cage. See
2.Disconnect all the connectors from the HVPS.
Note: When reinstalling flat cables, ensure that the blue side of the cable is opposite of the pins on the
connectors. Flat cable pins are exposed on only one side (opposite blue side) and must make contact with
the metal pins on the connectors.
3. Remove 11 screws (A) (4 corner screws are gold in color (metal); inner screws are silver (plastic));
remove HVPS.
"System board cage removal" on page
A
7100-XXX
4-38.
4-39
Repair information