Retrieving, Printing And Restoring The Mfp Settings; Printing The Maintenance And Configuration Pages; Setting The Country Code; Scanner Calibration And Registration - Lexmark X500n Service Manual

Lexmark confidential until announce edited 1/4/2007

Retrieving, printing and restoring the MFP settings

Printing the maintenance and configuration pages

Before replacing the engine controller board or the system / RIP board, print out the maintenance and
configuration pages. These page contain the MFP setting information that will need to be reset on the new
board.
Printing the maintenance page
1. in Ready mode, press
2. Press
twice to scroll to the Reports menu.
3. Press
.
4. Press
once to scroll to the Maintenance Page item.
5. Press and hold
Printing the configuration page
1. in Ready mode, press
2. Press
twice to scroll to the Reports menu.
3. Press
.
4. Press
XX times to scroll to Configuration Page.
5. Press and hold

Setting the country code

The country code must be reset when the system/RIP board is replaced. The country code setting
determines which communication protocols, compression settings, and signal strength settings will be used
for a given country or region. Failure to reset the country code can render the fax functionality unusable.
To set the country code, perform the following steps:
1. in Ready mode, press
2. Use the
or
3. Press
to select the Administration menu.
4. Use the
or
5. Use the
or
6. Press
to select and confirm the country or region.

Scanner calibration and registration

The X5xx scanner is self-calibrating. Scanner calibration occurs every time the MFP is started. in addition,
calibration is performed before a scan, copy or fax action is performed.
Top edge registration is performed when the MFP is powered on and before every scan, copy, or fax. Right
and left edge registrations are performed only when the MFP is started.
If the scanner fails to calibrate, 006 Service Call / Scanner Unit will be displayed. Should this error display,
see "Flatbed service check" on page
. The MFP will enter the admin menus.
. The maintenance page will print out.
. The MFP will enter the admin menus.
. The configuration page will print out.
to enter the MFP menus.
keys to scroll to the Administration menu.
keys to scroll to the Country menu.
keys to scroll to the desired country or region.
2-41.
7100-XXX
3-3
Diagnostic aids