Setting Up Chap Parameters For Software Initiators - HP StorageWorks 1510i - Modular Smart Array User Manual

3. To add a new iSCSI target that your ESX Server host can use for a SendTargets session, click Add.
The Add Send Targets Server dialog box displays.
4. Enter the Send Targets server IP address, and click OK.
5.
To change or delete a Send Targets server, select the server and click Edit or Remove.

Setting up CHAP parameters for software initiators

When configuring your iSCSI software initiator, make sure that CHAP parameters are enabled for
the initiator. If they are not enabled, set them up.
NOTE:
For more information, see
1.
Open the iSCSI Initiator Properties dialog box.
2.
Click the CHAP Authentication tab.
The tab displays the default CHAP parameters.
72
Configuration
"iSCSI security" on page 70.