Prerequisites; Connected To The Correct Lan Port - Fujitsu Remote Management User Manual

Configuring the LAN interface of the iRMC S2/S3
3.1.1

Prerequisites

Note the following requirements with respect to configuring the IP address:
– The LAN cable must be connected to the correct port. (see
"Connected to the correct LAN port?" on page
– Interaction between the IP addresses of the iRMC S2/S3 and the system
(see the section "Interaction between the IP addresses of the iRMC S2/S3
and the system" on page
3.1.1.1

Connected to the correct LAN port?

The interface for a LAN connection is provided on an onboard LAN controller
assigned to the iRMC S2/S3 (see also
Depending on the server type, the system board of a PRIMERGY server
provides two or three LAN interfaces. The ports marked with a wrench symbol
are assigned to the iRMC S2/S3 (in
the top left-hand port).
I
Check that the LAN cable is connected to the correct port.
Depending on the type of PRIMERGY server, different ports may be
marked with the wrench symbol.
Dedicated Service / Management LAN
(port exclusively for the
iRMC S2/S3; with the iRMC S3
a LAN speed up to 1000 MBit/s
is available, depending on the
server hardware.)
Figure 7: Ports for the iRMC S2/S3 (indicated by wrench symbol)
42
43).
figure 4 on page
figure 7, for example, these are port 1 and
(1)
LAN (port exclusively
(2)
for the system)
section
42).
27).
Shared LAN
(iRMC S2/S3 and system)
iRMC S2/S3