Firmware-Specific Commands - Fujitsu Remote Management User Manual

IPMI OEM Commands supported by the iRMC S2/S3

12.1.2.5 Firmware-specific commands

20 04 - Set Firmware Selector
This command configures the firmware image of the iRMC S2/S3 which is to be
active after a firmware reset.
Request Data
Response Data
396
- 20 NetFnlLUN: Firmware
- 04 CMD : Command Group Firmware
1 Selector:
0 = Auto (Select firmware image with highest firmware
version.)
1 = low firmware image
2 = high firmware image
3 = Auto oldest version (Select firmware image with oldest
firmware version.)
4 = MRP (Select most recently programmed firmware.)
5 = LRP (Select least recently programmed firmware.)
- 24
- 04
1 Completion Code
iRMC S2/S3