Service Processor - Ip Parameters, Identification Led And Irmc S2/S3 Reset - Fujitsu Remote Management User Manual

8.11 Service processor - IP parameters,
identification LED and iRMC S2/S3 reset
The following menu appears if you choose Service Processor... from the main
menu:
Figure 208: Remote Manager: Service Processor menu
The submenu contains the following functions:
Configure IP Parameters
List IP Parameters
Toggle Identify LED
Reset iRMC S2/S3
(Warm reset)
Reset iRMC S2/S3
(Cold reset)
Table 15: Service Processor menu
I
It is recommended that you reboot the server after a Reset iRMC S2/S3
(Cold Reset) or Reset iRMC S2/S3 (Warm Reset) (see
iRMC S2/S3
Configure the IPv4 / IPv6 address settings of the
iRMC S2/S3 in a guided dialog. Please refer to
section "Network Interface Settings - Configure
Ethernet settings on the iRMC S2/S3" on page 239
for details in the individual settings.
Display the IP settings.
Switch the PRIMERGY identification LED on/off.
Reset the iRMC S2/S3. The connection is closed.
Only the interfaces are re-initialized.
Reset the iRMC S2/S3. The connection is closed.
The entire iRMC S2/S3 is re-initialized.
Service Processor
page 189).
339