Booting The Managed Server From Serverview Suite Dvd 1 And Configuring It With The Installation Manager - Fujitsu Remote Management User Manual

11.3 Booting the managed server from
ServerView Suite DVD 1 and configuring it
with the Installation Manager
Proceed as follows at the remote workstation:
Ê Use the iRMC S2/S3 web interface to start up the managed server or reboot
the server (see
in the AVR window.
During the managed server's BIOS/TrustedCore/UEFI POST phase, remote
storage media are displayed as USB 2.0 devices. Remote Storage storage
media are represented by the following entries in the BIOS boot sequence:
– A (physical) floppy disk is represented by a separate entry
"FTS RemoteStorage FD-(USB 2.0)".
– All other remote storage device types are represented by the shared
entry "CD-ROM DRIVE".
I
If a local CD-ROM/DVD-ROM drive and a CD-ROM/DVD-ROM
drive connected as remote storage are both present at the
managed server then the managed server boots from the Remote
Storage CD-ROM/DVD-ROM drive.
Ê Press [F2] while the server is booting.
Ê In the BIOS/TrustedCore/UEFI set-up, open the menu Boot in which you can
define the boot sequence.
Ê Specify Boot Priority=1 (highest priority) for the ServerView Suite DVD 1
which is connected as remote storage.
Ê Save your settings and exit the BIOS/TrustedCore/UEFI setup.
The managed server then boots from ServerView Suite DVD 1 which is
connected as remote storage.
I
If the system does not boot from the remote storage medium
(ServerView Suite DVD 1 or Installation Manager boot image):
Ê Check whether the storage medium is displayed during the BIOS
POST phase and connect the storage medium as remote storage if
necessary.
Ê Make sure that the correct boot sequence is specified.
iRMC S2/S3
page 189). You can follow the progress of the boot process
Booting from DVD 1
377