General Troubleshooting; Printer Does Not Turn On - Xerox WorkCentre 7425 User Manual

General Troubleshooting

This section contains procedures to help you locate and resolve problems. Some problems can be
resolved by simply restarting the printer.
To restart the printer:
1. Locate the ON/OFF switch on the front of the printer below the control panel.
2. Turn the switch OFF, wait 20 seconds, and turn the switch back ON.
If the problem is not resolved by restarting the printer, see the table in this chapter that best describes
the problem.

Printer Does not Turn On

Probable Causes
The power cord is not correctly plugged into the
outlet.
Something is wrong with the outlet connected to the
printer.
The power switch is not correctly turned on.
The printer is connected to an outlet with a voltage or
frequency that does not match the printer
specifications.
Caution:
Plug the three-wire cord (with grounding prong) directly into a grounded AC outlet only.
Do not use a power strip. If necessary, contact a licensed electrician to install a properly grounded
outlet.
Solutions
Turn off the printer, then plug the power cord securely
into the outlet.
Plug another electrical appliance into the outlet and
see whether it operates properly.
Try a different outlet.
Turn the power switch off, wait two minutes, then
turn it back on.
Use a power source with the specifications listed in
Electrical Specifications
WorkCentre 7425/7428/7435
General Troubleshooting
on page 243.
User Guide
193