AT&T MERLIN LEGEND Release 4.0 Feature Reference page 381

Feature Reference
Park
At a Glance
Users Affected
Reports Affected
Mode
Telephones
Programming Codes
Park at own extension
Park Zone
MLX Display Label
Park at own extension
Park Zone
System Programming
Maximums
No. of parked calls in park
zones
Factory Settings
Park Zones
Call Park Return Interval
QCC Priority Level for
returning parked calls
Description
Park puts a call on a special type of hold, so that it can be picked up from any
extension in the system. A user can park a call and then pick it up at another
telephone or can use Paging to announce the call so that another person can
pick it up. A parked call is picked up by using the Pickup feature.
A user (excluding QCC operators) can park calls at his or her own extension by
activating Park during the call or by pressing the Transfer button, dialing his or
her own extension number, and pressing the Transfer button again to complete
the transfer. At least two SA or ICOM buttons are required to use Park this way,
and if a user must park more than one call, more SA or ICOM buttons should be
assigned to the telephone. The green LED winks at the button where the call is
parked and at all other associated SA and Shared SA buttons.
Telephone users, operators
Extension Information
Operator Information
System Information
All
All except single-line
+ park zone (DLC operators only)
[ ]
Assign return interval before unanswered parked call returns:
•
8 (one parked call for each zone)
881–888
180 sec (range 30–300 sec, in increments of 10 sec)
4 (range 1–7)
381
Park