AT&T MERLIN LEGEND Release 4.0 Feature Reference page 296

Feature Reference
Direct Station
Selector
Drop
Group Calling
Hold
Last Number Dial
Paging
Saved Number Dial
Transfer
296
Inspect
Inspect can be used to display limited information, such as extension
number and label and number of messages, for each DSS button. To
use Inspect, the operator presses the Page button for the range of
extensions, then the Inspct button, then the individual DSS button for an
extension. Inspect must be activated separately for each page on the
DSS; to inspect another page of extensions, the operator must press the
Home button and repeat the process.
When the operator inspects a DSS button associated with an extension,
Line 1 of the display shows the extension, the label associated with the
extension, if any, and the number of messages that have been left for
that extension, if any. It the extension has posted a message, Line 2
shows the posted message.
In Release 2.0 and later, the operator can inspect a DSS button with a
red LED on to see whether the extension is busy or using Do Not
Disturb. If the user at the extension has turned on Do Not Disturb, the
Do Not Disturb message is also posted and appears on the operator's
display. (However, the message may also mean that the user has
posted the message without turning on the Do Not Disturb feature.)
If the user presses the Drop button while active on a call with Inspect
activated, Inspect is canceled and the system attempts to activate the
Drop feature.
Any MLX telephone user can inspect the number of calls in the calling
group queue by pressing the Inspct button and then pressing a button
programmed with the calling group's extension (Calls-In-Queue Alarm
button). The display shows the label associated with the calling group
and the number of calls in the queue.
If the user presses the Hold button while active on a call with Inspect
activated, Inspect is canceled and the system tries to put the call on
hold.
Starting with Release 2.0, if a programmed Last Number Dial button is
inspected, the display shows the last number stored for dialing. If no
number was stored, the feature name is displayed.
If the user gets a voice-announced inside call or a group speakerphone
page while using the Inspect feature, the Inspect feature is canceled
and the user is returned to the Home screen.
Starting with Release 2.0, if a programmed Saved Number Dial button is
inspected, the display shows the last number stored for dialing. If no
number was stored, the feature name is displayed.
If a user tries to transfer a call by pressing the Transfer button while
active on a call with Inspect activated, Inspect is canceled and the user
is returned to the Home screen.