AT&T MERLIN 3070 Administration Manual page 90

Follow the procedure below to add voice terminals to or remove them from Night Ser-
vice groups.
1. If you have not already done
boxed instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing and the green
light next to Adm Misc becomes steady.
3. Dial the 4-character code #307
4. Dial the intercom number (10 to 14) of the attendant for whom you are set-
ting up or changing a Night Service group.
If you have an Auto Intercom button for the attendant's console the green light
next to the button flashes slowly
5. Touch the Auto intercom button of each voice terminal you want to add to or
remove from this attendant's group until the light beside the button shows
the appropriate code.
Green light on = voice terminal is included in the Night Service group,
Green Iight off = voice terminal is not included in the Night Service
group.
If you don't have an Auto intercom button for a voice terminal, use your dial
pad to add it to or remove it from a Night service group.
• To add the voice terminal, touch Hold, then dial its intercom number.
• To remove the voice terminal, touch Drop, then dial its intercom number.
• To remove all the voice terminals in the group, touch Drop
If you use Hold and Drop, the console will beep if you try to add a voice ter-
minal that is already in the group or to remove a voice terminal that is not in
the group.
6. Repeat steps 4 and 5 fur each Night Service group you want to set up or
change.
7. If you have a printer, you can order a printout to make sure your Night Ser-
vice groups are set up the way you want them. A typical printout appears on
the next page. To get a printout of the Night service Information Report, dial
the 4-character code #907.
The green light next to Adm Misc flashes. When the printout is completed,
you hear a beep and the green light next to Adm Misc becomes steady.
Don't go on to step 8 until you hear the beep or you will get an incomplete
printout. Wait to remove your printout until you have completed step 8 or your
page alignments will be affected.
8. Touch Adm Misc.
The lights next to the administration mode buttons flash.
9. Continue to administer your system, or leave administration mode by following
the boxed instruction on page 28.
, enter administration mode by following the
SO
then touch *.
J
87