AT&T MERLIN 3070 Administration Manual page 80

9. If you to remove any entry from a table, perform steps 3 through 5 and then touch Drop.
10. Repeat steps 3 through 8, or perform step 9, for each table entry you want
to administer. You must repeat steps 3 through 8 in order to add or change the pool
number, other digits, or absorption type of an entry.
11. To change th eOther Digits column of the Special Numbers Table., dial the 4-
character code #800 and perform one of the following operations:
• To add other digits, perform step 7.
• To remove other digits, touch Drop.
12. If you have a printer and want to see a printout of your ARS tables, go on to step 13 below.
If you want to activate ARS for your system at this time, perform step 3 of the procedure
headed "Activating and Deactivating ARS," on page 78
13. If you have a printer connected to your system, you can get a printout of the complete
set of ARS tables. To order a printout, dial the 4-character code #902.
The green light next to Adm Misc flashes. When the printout is compolete, you hear a beep,
and the green light next to Adm Misc becomes steady
Don't go on to step 14 until you hear the beep or you will ge an incomplete printout.
Don't remove your printout from the printer until you complete step 14 or your page alignments will.
be affected.
14. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
15. Continue to administer your system or leave administration mode by following
the boxed instructions on page 28.
77