AT&T MERLIN 3070 Administration Manual page 88

To administer One-Touch Hold with Call Announcement or to change from One-Touch
Hold with Call Announcement to One-Touch Transfer, follow the procedure below.
1, If you have not already done so, enter administration mode by following the
boxed instruction on page 28,
2. Touch Admn Misc.
The lights next to the administration mode buttons stop flashing and the green
light next to Adm Misc becomes steady.
3. Dial the 4-character code #315, then perform one of fhe following operations:
• If you want One-Touch Transfer, dial 0.
• If you want One-touch Hold with Call Announcement, dial 1.
4. If you have a printer connected to your system, you can make sure that you
have selected the option you want by getting a System Information Report.
A typical printout appears below. To order a printout, dial the 4-character code
#905.
The green light next to Adm Misc flashes. When the printout is completed,
you hear a beep and the green light next to Adm Misc becomes steady.
Don't go on to step 5 until you hear the beep or you will get an incomplete
printout. Wait to remove your printout until you have completed step 5 or your
page alignments will be affected.
5. Touch Adm Misc.
The lights next to the adminisration mode buttons flash again..
6. Continue to administer your system, or leave administration mode by following
the boxed instructions on page 28.
A
SYSTEM INFORMATION
A
SMDR Incoming Calls Recorded: YES
A
SMDR Minimum Call Lenght: 00 minutes
A
C u r r e n t D a t e : 0 3 / 3 1 / 8 6
A
C u r r e n t T i m e : 1 3 : 2 8 : 2 2
A l n c o m p a t i b l e
A
T a n s f e r R e t u r n T i m e r : A
A t t e n d a n t I n t e r c o m
A
Dialing Time Out: 0
A
A
Recall Timer : 450
w i t h C M S
A u t o D i a l W i t h : T r a n s f e r
8 5