AT&T MERLIN 3070 Administration Manual page 116

Use Centralized Voice Terminal Programming or follow the procedure below to assign
Cover buttons.
1. Go to the voice terminal you want to program.
2. Label the Cover button with the name of the person whose calls will be
covered (for example, "Cover Susan").
3. Slide the T/P switch on the left side of the voice terminal to P .
The voice terminal rings every 5 seconds to remind you it is in program mode.
4. Touch the button you want to be the Cover button. You must use a programmable
button with lights, and you may program no more than six cover buttons on
any one voice terminal.
5. Dial 4 to program primary coverage, or dial *5 to program secondary coverage.
6. Dial the 2-digit intercom number of the voice terminal you want the button to cover.
7. Cover buttons are set initially for no ring.
ringing option, touch the Cover button until the red light beside it shows the appro-
priate code. Each successive touch gives you one of the following code:
Steady red light on = immediate ring
Flashing red light = delayed ring
Red light off = no ring
If the green light beside the Cover button flashes and you hear a beep, you
have not performed the procedure correctly.
8. If you have more options to program on this voice terminal, you can do so.
Otherwise, slide the T/P switch to the center position to return to normal operation.
To select the preferred line
Repeat steps 4 throug 7.
113