AT&T MERLIN 3070 Administration Manual page 53

5 0
Follow the procedure below to set up allowed lists.
1. If you have not alrady done so, enter administration mode by follow-
ing the boxed instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the
green light next to Adm Misc becomes steady
3. Dial the 2-character code #5.
4. Dial the list number (0 through 7).
5. Dial the number (0 through 9) of the entry you want to record.
6. Dial the new entry, which may consist of an area code, an exchange
code, or both. The entry may also be a special-purpose number such
as 911.
7. Repeat steps 3 through 6 to add more entries to the same list or to add
entries to a different list.
8. If you want to remove an entry from a list, perform steps 3 through
5 and touch Drop.
9. If you have a printer connected to your system, you can order a prin-
tout of any of your allowed Iists. To get a printout, repeat steps 3 and
4, then dial the 5-character code 0#900.
When the printout is completed, you hear a beep.
Don't go on to step 10 until you hear the beep or you will get an in-
complete printout. Don't remove the printout until you have completed
step 10 or your page alignments will be affected.
10. Touch Adm Misc.
The lights next to the administration mode button flash again.
11. Continue to administer your system or leave administration mode by
following the boxed instructions on page 28.
A printout of a typical allowed list is shown below.
A
A
A
A
A
A
A
A
A
A
A
A L L O W E D L I S T #
ENTRY # 0: 212566
ENTRY # 1: 805462
ENTRY # 2: 404
ENTRY # 3: 504832
ENTRY # 4: 957
ENTRY # 5: 318
ENTRY # 6: 907562
ENTRY # 7: 205353
ENTRY # 8: 207761
ENTRY # 9: 406586
2