AT&T MERLIN 3070 Administration Manual page 103

100
Follow the procedure below to administer SMDR. If you hear a beep after you dial
an entry, try dialing it again. If you continue to get an error tone for an entry that you're
sure is correct, the SMDR board may not be fully installed, and you'll need to con-
sult your installer.
1. If you have not already done so, enter administration mode by following the boxed
instructions on page 28.
2. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the green
light next to Adm Misc become steady.
3. To set the time, dial the 4-character code #300 plus two digits for hours and two digits
for minutes in the 24- hour format.
For example, if the time is 6:23 A.M., dial the 8-character code #3000623. If the time is
6:23 P.M., dial the 8-character code #3001823
NOTE: If you change the time etting for SMDR while Night Service is in effect, Night Service
will go off. You must reactivate it by following the instructions on page 95
4. To set the date, dial the 4-character code #301 and then dial two digits for the month,
two digits for the day, and two digits for the year.
For example, if the date is March 15, 1995, dial the 10-character code #301031585.
5. To specify minimum length of more than 1 minute for SMDR calls, dial the 4-
character code #390 and then dial two digits for minutes.
For example, if you want to specify a minimum lenght of 2 minutes, dial the 6-character code
#39002. To specify a minimum of 0 minutes, the only minimum lenght shorter than 1 minute
that the system can set, dial the 6-character code #39000.
6 . T o s p e c i f y S M D R f o r i n c o m i n g c a l l s , d i a l o n e o f t h e f o l l o w i n g c o d e :
If you want incoming calls as well as outgoing calls printed, dial the 5-character
code #3911.
If you want only outgoing calls printed, dial 5-character code #3910.
7. You may want to verify that SMDR is administered the way you want it.
printout of SMDR options is shown below. To get a printout of the SMDR options
dial the 4-character code #905 or the 8-character code #390#900.
The green light next to Adm Misc flashes.
When the printout is completed, a beep sounds and the green light next to Adm Misc
becomes steady.
Don't go on to step 8 until you hear the beep, or you will get an incomplete
printout. Don't remove your printout until you have completed step 8 or your page
alignments will be affected.
8 . T o u c h A d m M i s c .
The lights next to the administration mode buttons flash again.
9. Continue to administer your system, or leave administration mode by following
the boxed instructions on page 28.
A S M D R O P T I O N S
A SMDR Incoming Calls Recorded: YES
A SMDR Minimum Call Length: 00 minutes
TYPICAL PRINTOUT OF SMDR OPTIONS
A typical