AT&T MERLIN 3070 Administration Manual page 126

Now, use the sample procedures below as guidelines to program special characters
into a dialing sequence.
1. Go to the voice terminal you want to program.
2. Label the button with the person's or service's name.
3. Slide the T/P switch on the left side of the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program mode.
4. Touch the button you have labeled for Outside Auto Dial.
Dial *90.
6. To program a pause (1.5 seconds) into a dialing sequence (for example, bet-
ween an alternate long distance company telephone number and its access code):
a. Dial 9 or another outside line access code.
b. Touch Hold (Pause).
c. Dial the outside number you want the button to represent.
7. To program a stop into a dialing sequence (for example, between a local
telephone number and an alternate long distance authorization code):
a. Dial the local telephone number (seven digits)
b. Touch Drop (Stop).
c. Dial the authorization code (five or six digits)
8. To program Touch-Tone Enable into a dialing sequence (for example, between
a telephone number and a credit card authorization code):
a. Dial the telephone number.
b. Touch Transfer.
c. Dial the credit card authorization code.
9. To program a switchhook flash into a dialing sequence (for example, for a
Custom Calling, PBX, or Centrex code that calls for a switchhook flash):
a. Touch Recall.
b. Touch Hold (Pause).
c. Dial the PBX or Centrex dial code sequence that accesses the feature
you want to program.
10. To program a # onto a MERLIN system Outside Auto Dial button to access
certain PBX or Centrex features:
a. Touch the Outside Auto Dial button you want to program with a #.
b. Dial the 5-character *90 ##.
c. Dial the PBX or Centrex dial code sequence that accesses the feature
you want to program.
11. If you have more options to program on this voice terminal, you can do so.
Otherwise, slide the T/P switch to the center position to return to normal
operation.
123