AT&T MERLIN 3070 Administration Manual page 100

Follow the procedure below to assign System Speed Dial Codes.
1. If you have not already done so, enter administration mode by following the boxed instructions on page 28.
2. Touch Conference.
The red light next to Adm Tel goes on.
3. Dial 0.
4. Dial the 3-character code (#60 through #99) that you want to assign to the telephone number.
5. If you ae storing a marked Speed Dial code, dial * after dialing the Speed Dial code.
6. Dial the telephone number. A number for a marked Speed Dial code can have a maximum of 39 characters;
a number for an unmarked Speed Dial code can have up to 40 characters. These characters can include Hold (Pause)
for a pause, Drop (Stop) for a stop, Transfer for Touch-Tone enable, and Recall, for a switchhook flash.
7. Repeat steps 4 through 6 for each System Dial code you want to assign.
8. Touch Conference twice.
9. If you have a printer connected to your system, you can follow the procedure below to get a printout of your
System Speed Dial code numbers. An example of a portion of this type of printout appears on page 98.
a. Touch Adm Misc.
The lights next to the administration mode buttons stop flashing, and the green light next to Adm Misc
becomes steady.
b. Dial the 4-character code #901
The green light next to Adm Misc flashes.
All 40 codes (#60 through #99) are printed out, even if somes are not yet assigned to telephone
numbers. If a number includes special characters, they will appear as t for Touch-Tone enable, s for stop,
p for pause, or r for recall.
When the printout is completed, you hear a beep and the green light next to Adm Misc becomes steady.
Don't go on to step (c) until you hear the beep or you will get an incomplete printout. Don't remove your printout
until you complete step (c) or your page alignments will be affected.
c. Touch Adm Misc.
The lights next to the administration mode buttons flash again.
10. Continue to administer your system, or leave administration mode following the boxed instructions on page 28.
9 7