Brother PE-DESIGN2.0 Instruction Manual page 88

Running stitch
Run pitch
Run times
In Region Sewing Mode, the
you can change the settings of the stitch selected in the
Attributes bar. The other stitch settings display in gray.
Example of the
Region sewing attribute
Fill stitch, Satin stitch and Programmed fill stitch:
Under sewing
Density
Direction
78
Sets the pitch of the line sewing (when
Range: 1 ~ 10 mm (0.04 ~ 0.39 inch)
Default: 2 mm (0.08 inch)
Sets the number of times the border will be sewn (when
selected for the outline).
Range: 2, 4, 6
Default: 2
Sewing Attribute Setting
Sewing Attribute Setting
Sets under sewing on/off. Try to use Under sewing for wide areas, in
order to prevent shrinking during stitching. Depending on the shape
of the region, however, it may not be possible to make this setting.
Sets the number of lines per mm.
Range: 1 ~ 7 lines per mm (25 ~ 178 lines per inch)
Default: 4.5 lines per mm (114 lines per inch)
Sets the direction of the stitch.
Range: 0 ~ 179 degrees
Default: 45 degrees
Running Stitch
dialog displays the
Region sew type
dialog for a Programmed Fill Stitch:
Enter the desired values for each set-
ting either by clicking on the arrows or
by typing the value directly in the edit
box window.
•
When you click a selector, a preview
image of that setting displays.
The image will change and reflect your
setting changes each time you click an
arrow.
To restore the default value of an indi-
vidual setting, click its
Click the region(s) you want to apply
the selected settings to.
Click
is selected for the outline).
Running Stitch
Region sewing
selector of the Sewing
Default
to exit.
Close
135˚
179˚
is
tab. Here
button.
90˚
45˚
0˚