Brother PE-DESIGN2.0 Instruction Manual page 177

You should never remove a card while the red indicator light in on. If you do so, you will have to
restart the operation from the start.
If you did not remove the card and the above message appears, then the card is defective or was
not well inserted. Reinsert the card correctly and try writing again. If you get the same message,
then the card is defective. Try with another card.
6
If the data cable between the card module and the computer or the power adaptor is disconnected
while writing is in progress, writing will stop and this message will display:
Check all the connections and correct as necessary, then try again from the start.
If the connections are correct, then a cable may be defective. Consult your dealer.
7
When every COM port is already in use for other peripherals, the following message appears.
Disconnect a peripheral connected to your computer and try again.
Click to remove the message.
OK
Click to remove the message.
OK
167