Set Hole Sewing - Brother PE-DESIGN2.0 Instruction Manual

Set hole sewing

Purpose:
Shortcut key:
Toolbar:
Operation:
1
Select a pair of patterns, for example, a rectangle included in another rectangle.
2
Click , then
Sew Set Hole Sewing
This message will display.
3
Once a pair of patterns has been set for hole sewing, they are grouped and will move together if
you try to move one of the patterns. To change their relative position, you will have to cancel hole
sewing first.
Hole sewing not set
If the selected pair cannot be set for hole sewing, this message displays.
For a pair to be valid, one of the pattern must be completely enclosed within the other pattern of
the pair.
Valid
Note that you can see better what the hole sewing setting does by previewing the pair before and
after setting the pair for hole sewing (see "Preview" on page 153).
See also:
148
Sets a pair of patterns for hole sewing (to avoid sewing twice at the same place
when a pattern covers another one).
No shortcut key for this function
No button for this function
.
Sewn twice
Hole sewing set
"Cancel hole sewing"
Click to remove the message.
OK
Sewn once
Click to remove the message.
OK
Invalid