Error Messages - Brother PE-DESIGN2.0 Instruction Manual

Error Messages

The application is able to detect problems that may occur before or during data transfer. Here is the com-
plete list of error messages that may appear.
1
If the card module is not correctly connected:
2
If there is no card in the card module:
3
If an incorrect or defective card is inserted:
4
If a defect is detected after reading has already started, or if you remove the card while reading is
in progress, reading will stop and this message will display:
You should never remove a card while the red indicator light in on. If you do so, you will have to
restart the operation from the start.
If you did not remove the card and the above message appears, then the card is defective or was
not well inserted. Reinsert the card correctly and try reading again. If you get the same message,
then the card is defective. Try with another card.
162
Correct the connection between the
card module and the computer.
Check that the module is powered.
Click to start reading.
Retry
Click to exit.
Cancel
Insert a Embroidery card in the
module.
Click to start reading.
Retry
Click to exit.
Cancel
Insert another Embroidery card in
the module.
Click to start reading.
Retry
Click to exit.
Cancel
Click to remove the message.
OK