Filter Control - Vlan Id - 3Com 3CRWE876075 User Manual

A VLAN ID (1-4094) can be assigned to a client after successful IEEE 802.1X
authentication. The client VLAN IDs must be configured on the RADIUS server for
each user authorized to access the network. If a client does not have a configured
VLAN ID on the RADIUS server, the access point assigns the client to the
configured default VLAN ID for the VAP interface.
NOTE: When using IEEE 802.1X to dynamically assign VLAN IDs, the access point
must have 802.1X authentication enabled and a RADIUS server configured.
Wireless clients must also support 802.1X client software.
When setting up VLAN IDs for each user on the RADIUS server, be sure to use the
RADIUS attributes and values as indicated in the following table.
Number RADIUS Attribute
64 Tunnel-Type
65 Tunnel-Medium-Type
81 Tunnel-Private-Group-ID
VLAN IDs on the RADIUS server can be entered as hexadecimal digits or a string
(see "radius-server vlan-format" on page 5-69).
NOTE: The specific configuration of RADIUS server software is beyond the scope
of this guide. Refer to the documentation provided with the RADIUS server
software.
Figure 25 Filter Control - VLAN ID
VLAN – Enables or disables VLAN tagging support on the access point.
Management VLAN ID – The VLAN ID that traffic must have to be able to manage
the access point. (Range 1-4094; Default: 1)
4-17
Filter Control
Value
VLAN (13)
802
VLANID
(1 to 4094 as hexadecimal or string)