General Commands - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE
Command Group
WDS Bridge
Spanning Tree
Ethernet Interface
Wireless Interface
Wireless Security
Rogue AP Detection
Link Integrity
IAPP
VLANs
WMM
The access mode shown in the following tables is indicated by these
abbreviations: Exec (Executive Mode), GC (Global Configuration), IC-E
(Interface-Ethernet Configuration), IC-W (Interface-Wireless Configuration), and
IC-W-VAP (Interface-Wireless VAP Configuration).

General Commands

Table 11 General Commands
Command
configure
end
exit
ping
reset
show history
show line
configure
This command activates Global Configuration mode. You must enter this mode to
modify most of the settings on the access point. You must also enter Global
Configuration mode prior to enabling the context modes for Interface
Configuration. See "Using the Command Line Interface" on page 5-1.
I
NTERFACE
Description
Configures WDS forwarding table settings
Configures spanning tree parameters
Configures connection parameters for the Ethernet interface
Configures radio interface settings
Configures radio interface security and encryption settings
Configures settings for the detection of rogue access points in the
network
Configures a link check to a host device on the wired network
Enables roaming between multi-vendor access points
Configures VLAN membership
Configures WMM quality of service parameters
Function
Activates global configuration mode
Returns to previous configuration mode
Returns to the previous configuration mode, or exits the CLI
Sends ICMP echo request packets to another node on the
network
Restarts the system
Shows the command history buffer
Shows the configuration settings for the console port
5-8
Page
5-84
5-91
5-97
5-103
5-125
5-125
5-141
5-144
5-145
5-148
Mode Page
Exec 5-8
GC, IC 5-9
any 5-10
Exec 5-10
Exec 5-11
Exec 5-12
Exec 5-12