Spanning Tree Commands; Bridge Commands - 3Com 3CRWE876075 User Manual

Enterprise AP#show bridge link wireless a 2
Port-No
status
state
priority
path cost
message age Timer
message age
designated-root : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-cost : 0
designated-bridge : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-port : priority = 0, port No = 11
forward-transitions : 0
Enterprise AP#
Enterprise AP#show bridge link ethernet
status
state
priority
path cost
message age Timer
message age
designated-root : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-cost : 0
designated-bridge : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-port : priority = 0, port No = 1
forward-transitions : 1
Enterprise AP#

Spanning Tree Commands

The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
Table 24 Bridge Commands
Command
bridge stp enable
bridge stp forwarding-delay
bridge stp hello-time
bridge stp max-age
bridge stp priority
bridge-link path-cost
bridge-link port-priority
: 11
: Enabled
: Disabled
: 0
: 19
: Inactive
: 4469
: Enabled
: Forwarding
: 0
: 19
: Inactive
: 4346
Function
Enables the Spanning Tree feature
Configures the spanning tree bridge forward time
Configures the spanning tree bridge hello time
Configures the spanning tree bridge maximum age
Configures the spanning tree bridge priority
Configures the spanning tree path cost of a port
Configures the spanning tree priority of a port
5-91
Using the Command Line Interface
Mode
GC
GC
GC
GC
GC
IC
IC
Page
5-92
5-92
5-93
5-94
5-94
5-95
5-96