Snmp Commands - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE

SNMP Commands

Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 17 SNMP Commands
Command
snmp-server community
snmp-server contact
snmp-server location
snmp-server enable server
snmp-server host
snmp-server trap
snmp-server engine id
snmp-server user
snmp-server targets
snmp-server filter
snmp-server
filter-assignments
show snmp groups
show snmp users
show snmp
group-assignments
show snmp target
show snmp filter
show snmp
filter-assignments
show snmp
I
NTERFACE
Function
Sets up the community access string to permit access
to SNMP commands
Sets the system contact string
Sets the system location string
Enables SNMP service and traps
Specifies the recipient of an SNMP notification
operation
Enables specific SNMP notifications
Sets the engine ID for SNMP v3
Sets the name of the SNMP v3 user
Configures SNMP v3 notification targets
Configures SNMP v3 notification filters
Assigns SNMP v3 notification filters to targets
Displays the pre-defined SNMP v3 groups
Displays SNMP v3 user settings
Displays the assignment of users to SNMP v3 groups Exec
Displays the SNMP v3 notification targets
Displays the SNMP v3 notification filters
Displays the SNMP v3 notification filter assignments
Displays the status of SNMP communications
5-44
Mode Page
GC 5-45
GC 5-45
GC 5-46
GC 5-47
GC 5-47
GC 5-48
GC 5-50
GC 5-51
GC 5-52
GC 5-53
GC 5-54
Exec 5-55
Exec 5-56
5-56
Exec 5-57
Exec 5-57
Exec 5-58
Exec 5-59