Wds Bridge Commands - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE
Example
Enterprise AP#show filters
Protocol Filter Information
=======================================================================
Local Bridge
AP Management
Ethernet Type Filter :DISABLED
UPlink Access Table
-----------------------------------------------------------------------
UPlink access control:Enabled
UPlink MAC access control list
00-12-34-56-78-9a
-----------------------------------------------------------------------
Enabled Protocol Filters
-----------------------------------------------------------------------
No protocol filters are enabled
=======================================================================
Enterprise AP#

WDS Bridge Commands

The commands described in this section are used to set the operation mode for
each access point interface and configure WIreless Distribution System (WDS)
forwarding table settings.
Table 23 WDS Bridge Commands
Command
bridge role
bridge-link parent
bridge-link child
bridge dynamic-entry
age-time
show bridge aging-time
show bridge filter-entry
show bridge link
I
NTERFACE
:Traffic among all client STAs blocked
:ENABLED
Function
Selects the bridge operation mode for a radio interface IC-W
Configures the MAC addresses of the parent bridge
node
Configures MAC addresses of connected child bridge
nodes
Sets the aging time for dynamic entries in the WDS
forwarding table
Displays the current WDS forwarding table aging time Exec
Displays current entries in the bridge MAC address
table
Displays current bridge settings for specified interfaces Exec
:
5-84
Mode Page
5-85
IC-W 5-86
IC-W 5-86
GC 5-87
5-88
Exec 5-89
5-90