Wmm Commands - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE
Example
Enterprise AP(if-wireless g: VAP[0])#vlan-id 3
Enterprise AP(if-wireless g: VAP[0])#

WMM Commands

The access point implements QoS using the Wi-Fi Multimedia (WMM) standard.
Using WMM, the access point is able to prioritize traffic and optimize
performance when multiple applications compete for wireless network
bandwidth at the same time. WMM employs techniques that are a subset of the
developing IEEE 802.11e QoS standard and it enables the access point to
inter-operate with both WMM- enabled clients and other devices that may lack
any WMM functionality.
The WMM commands supported by the access point are listed below.
Table 31 WMM Commands
Command
wmm
wmm-acknowledge-
policy
wmmparam
wmm
This command sets the WMM operational mode on the access point. Use the no
form to disable WMM.
Syntax
I
NTERFACE
• If the VLAN ID has not been configured for a client on the RADIUS server,
then the frames are tagged with the default VLAN ID of the VAP interface.
Function
Sets the WMM operational mode on the access point
Allows the acknowledgement wait time to be enabled
or disabled for each Access Category (AC)
Configures detailed WMM parameters that apply to the
access point (AP) or the wireless clients (BSS)
[no] wmm <supported | required>
• supported - WMM will be used for any associated device that supports
this feature. Devices that do not support this feature may still associate
with the access point.
• required - WMM must be supported on any device trying to associated
with the access point. Devices that do not support this feature will not be
allowed to associate with the access point.
5-148
Mode Page
IC-W 5-148
IC-W 5-149
IC-W 5-150