Checking The Leds; Reset Button - 3Com 3CRWE876075 User Manual

C
HECKING THE
When power is connected, the access point LEDs light. The illustration and the
following table describe the LEDs and their functions.
Table 1 System LEDs
R
This button is used to reset the access point or restore the factory default
configuration. If you hold down the button for less than 5 seconds, the access
point will perform a hardware reset. If you hold down the button for 10 seconds
or more, any configuration changes you may have made are removed, and the
factory default configuration is restored to the access point.
LED
S
B
ESET UTTON
LED Color Indicates
Power Green The access point is powered up
and operating normally.
Off The access point is not receiving
power or there is a fault with the
power supply.
Link Green The access point has a 10/100
Mbps Fast Ethernet connection.
Flashing Indicates that the access point is
transmitting or receiving data on a
10/100 Mbps Ethernet LAN.
Flashing rate is proportional to
network activity.
Off No link is present.
11a Green The access point has WLAN frame
transmission over the 802.11a 5.3
GHz radio band.
Off No link is present.
11g Green The access point has WLAN frame
transmission over the 802.11g 2.4
GHz radio band.
Off No link is present.
2-9

Checking the LEDs