Turbo - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE
Example
Enterprise AP(if-wireless g)#speed 6
Enterprise AP(if-wireless g)#

turbo

This command sets the access point to an enhanced proprietary modulation
mode (not regulated in IEEE 802.11a) that provides a higher data rate of up to
108 Mbps.
Syntax
Default Setting
Command Mode
Command Usage
Example
Enterprise AP(if-wireless a)#turbo
Enterprise AP(if-wireless a)#
I
NTERFACE
turbo <static | dynamic>
no turbo
static - Always uses turbo mode.
dynamic - Will use turbo mode when no other nearby access points are
detected or active.
Disabled
Interface Configuration (Wireless - 802.11a)
• The normal 802.11a wireless operation mode provides connections up to
54 Mbps. Turbo Mode is an enhanced mode (not regulated in IEEE
802.11a) that provides a higher data rate of up to 108 Mbps. Enabling
Turbo Mode allows the access point to provide connections up to
108 Mbps.
• In normal mode, the access point provides a channel bandwidth of
20 MHz, and supports the maximum number of channels permitted by
local regulations (e.g., 11 channels for the United States). In Turbo Mode,
the channel bandwidth is increased to 40 MHz to support the increased
data rate. However, this reduces the number of channels supported (e.g.,
5 channels for the United States).
5-106