Configuration Commands; Command Line Processing - 3Com 3CRWE876075 User Manual

C 5: C L
HAPTER OMMAND INE

Configuration Commands

Configuration commands are used to modify access point settings. These
commands modify the running configuration and are saved in memory.
The configuration commands are organized into four different modes:
• Global Configuration (GC) - These commands modify the system level
• Interface-Ethernet Configuration (IC-E) - These commands modify the Ethernet
• Interface-Wireless Configuration (IC-W) - These commands modify the wireless
• Interface-Wireless Virtual Access Point Configuration (IC-W-VAP) - These
To enter the Global Configuration mode, enter the command configure in Exec
mode. The system prompt will change to "Enterprise AP(config)#" which gives
you access privilege to all Global Configuration commands.
Enterprise AP#configure
Enterprise AP(config)#
To enter Interface mode, you must enter the "interface ethernet," or
"interface wireless a," or "interface wireless g" command while in Global
Configuration mode. The system prompt will change to "Enterprise
AP(if-ethernet)#," or Enterprise AP(if-wireless)" indicating that you have access
privileges to the associated commands. You can use the end command to return
to the Exec mode.
Enterprise AP(config)#interface ethernet
Enterprise AP(if-ethernet)#

Command Line Processing

Commands are not case sensitive. You can abbreviate commands and parameters
as long as they contain enough letters to differentiate them from any other
currently available commands or parameters. You can use the Tab key to
complete partial commands, or enter a partial command followed by the "?"
character to display a list of possible matches. You can also use the following
editing keystrokes for command-line processing:
I
NTERFACE
configuration, and include commands such as username and password.
port configuration, and include command such as dns and ip.
port configuration of global parameters for the radio, and include commands
such as channel and transmit-power.
commands modify the wireless port configuration for each VAP, and include
commands such as ssid and authentication.
5-6