Filtering By Ethernet Protocol Type; Snmp - 3Com 3CRWE825075A User Manual

the airport. However the client to client blocking feature of the AP will only block
communications to other clients associated with the same AP. And will not block client
to client of another AP communications. By using the Uplink Filtering function of the
AP communications to all other clients of all other AP's on the same sub net can be
blocked.
It is important to note that this feature only works if all the AP's are on the same sub
net. If an AP is located on the far side of the gateway (i.e. on a different sub net) its
clients will NOT be blocked from communicating with clients on the local sub net of
interest.
This feature is accessed on the Filter Page of the user interface. Click on the Uplink
Filter List link and add up to eight MAC addresses that WILL be allowed to
communicate with clients of the AP. Make sure to include the MAC of the local
DHCP server, if it not the same as the gateway as well as and redirect gateways and
other servers that should be allowed to communicate with the AP's wireless clients.
Make sure to click on the save button on both the Uplink Filter List page as well as the
Filter page to activate the function.
F
Use the Ethernet Type Filter table to filter out Ethernet packet frames that match the
Ethernet protocol type. Select Ethernet Type Filter Enable, then set the status of each
Ethernet frame type in the list.
Although there are five types of IPX packets, the Filter Control page shows only two
options for IPX filtering. The following table shows how to filter each IPX packet
type:

SNMP

Use the SNMP page to display and enter a community string for the Simple Network
Management Protocol. To communicate with the access point, the SNMP agent must
first be enabled and the Network Management Station must submit a valid community
E
ILTERING BY THERNET
ISO Designator
8138
8137
802.3(Raw)
802.2
SNAP
P
ROTOCOL
Filter
Enable 8138
Enable 8137
Enable 8138
Enable 8138
Enable 8137
37
T
YPE