Changing Snmp Settings - 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge User Manual

38 C
HAPTER
Changing SNMP
Settings
Downloaded from www.Manualslib.com
3: C B
ONFIGURING THE RIDGE
Table 12 RADIUS Authentication Server Settings (continued)
Secondary RADIUS
Server
Secondary RADIUS
Port
Secondary RADIUS
Secret
Under System Configuration, click SNMP to display and change settings
for the Simple Network Management Protocol.
To communicate with the Bridge, the SNMP agent must first be enabled
and the Network Management Station must submit a valid community
string for authentication. Select SNMP Enable and enter data into the
fields as described below. When you are finished, click Apply.
Table 13 SNMP Settings
Setting
SNMP
Contact
Community Name
(Read Only)
Community Name
(Read/Write)
Trap Destination
IP Address
Trap Destination
Community Name
manuals search engine
Enter the IP address of the secondary RADIUS Authentication
Server. Make sure this address matches the address set in the
RADIUS Authentication software.
Enter the port number of the secondary RADIUS
Authentication Server. Make sure this number matches the
number set in the RADIUS Authentication software. The
default port is 1812.
Enter the password of the secondary RADIUS Authentication
Server. Make sure this password matches the password set in
the RADIUS Authentication software.
Description
Enables or disables SNMP.
Sets the location string that describes the system location.
Maximum length: 255 characters.
Specifies a community string with read-only access.
Authorized management stations are able to retrieve MIB
objects. Maximum length: 23 characters.
Specifies a community string with read-write access.
Authorized management stations are able to both retrieve
and modify MIB objects. Maximum length: 23 characters.
Enter the IP address of the trap manager that will receive
these messages.
Enter the community name of the trap manager that will
receive these messages.