Display Xrn-Fabric; Fabric Member-Auto-Update Software Enable - 3Com 5500-EI PWR Reference Manual

display xrn-fabric

Syntax
display xrn-fabric [ port ]
View
Any view
Parameters
port: Displays the fabric port information.
Description
Use the display xrn-fabric command to view the information of the entire fabric, including unit ID, unit
name, and operation mode of the system. If the fabric information is displayed on the console port of a
device, an asterisk (*) will be added to the unit ID of the current device.
Examples
# Display fabric information on the console port of unit 1.
<Sysname> display xrn-fabric
Fabric name is Sysname, system mode is L3.
Unit Name
First
Second
From the above example, you can see the following:
The name of the fabric is Sysname.
The system operation mode is Layer 3 forwarding.
The current device is 1 (marked by *)
The name of the current device is First (the name of a device can be configured by using the set
unit name command)
The other unit in the fabric is numbered 2
# Display the fabric port of the current device.
<Sysname> display xrn-fabric port
GigabitEthernet1/0/25
Fabric peer: Unknown
Fabric Status:
Fabric mode: Unknown-speed mode, Unknown-duplex mode
input: 0 packets, 0 bytes, 0 input errors
output: 7343 packets, 2250406 bytes, 0 output errors

fabric member-auto-update software enable

Syntax
fabric member-auto-update software enable
undo fabric member-auto-update software enable
Unknown
Unit ID
1(*)
2
1-7