Smart-Link Group - 3Com 5500-EI PWR Reference Manual

The VLAN configured as a control VLAN for sending or receiving flush messages must exist. You
cannot directly remove the control VLAN. When a dynamic VLAN is configured as a control VLAN for
the smart link group, this VLAN will become a static VLAN, and related prompt information is displayed.
Examples
# Enable Ethernet 1/0/4 to process flush messages received from control VLAN 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/4
[Sysname-Ethernet1/0/4] smart-link flush enable control-vlan 1
# Enable Ethernet 1/0/5 through Ethernet 1/0/10 to process flush messages received from control
VLAN 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link flush enable control-vlan 1 port Ethernet 1/0/5 to Ethernet 1/0/10

smart-link group

Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
Parameters
group-id: Smart link group ID, in the range of 1 to 24.
Description
Use the smart-link group command to create a smart link group and enter smart link group view. If the
specified smart link group exists, this command leads you into smart link group view directly.
Use the undo smart-link group command to remove the specified smart link group.
After creating a smart link group, you must configure member ports for this smart link group.
Related commands: port smart-link group, link-aggregation group, port.
1-7