Get - 3Com 5500-EI PWR Reference Manual

Description
Use the ftp source-ip command to specify the source IP address of that the switch uses every time it
connects to an FTP server, and the configuration will be saved to the configuration file of the system.
The value of argument ip-address must be an IP address on the device where the configuration is
performed. Otherwise, a prompt appears to show the configuration fails.
Use the undo ftp source-ip command to cancel the source IP address setting.
By default, the switch uses the IP address of the outbound interface in the local routing table as the
source IP address for connecting to an FTP server. The destination of the outbound interface is the
subnet where the FTP server resides.
Examples
# Specify 192.168.0.1 as the source IP address that the switch uses every time it connects to an FTP
server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ftp source-ip 192.168.0.1

get

Syntax
get remotefile [ localfile ]
View
FTP client view
Parameters
remotefile: Name of a file to be downloaded.
localfile: File name used when a file is downloaded and saved to the local device. If this argument is not
specified, the source file name is used when a file is saved and downloaded to the local device.
Description
Use the get command to download a remote file and save it as a local file.
When using the get command to download files from a remote FTP server, note to limit the length of file
path and file name within the following ranges:
A directory name should be no more than 91 characters.
A file name plus its local path name should be no more than 127 characters.
A device name should be no more than 14 characters.
A file name plus its complete path name should be no more than 142 characters.
1-16