Lldp Fast-Count - 3Com 5500-EI PWR Reference Manual

Description
Use the lldp encapsulation snap command to configure the encapsulation format for LLDPDUs as
SNAP on a port or a group of ports.
Use the undo lldp encapsulation [ snap ] command to restore the default encapsulation format for
LLDPDUs.
By default, Ethernet II encapsulation applies.
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp encapsulation snap

lldp fast-count

Syntax
lldp fast-count value
undo lldp fast-count
View
System view
Parameters
value: Number of the LLDPDUs to be sent successively when a new neighboring device is detected.
This argument ranges from 1 to 10.
Description
Use the lldp fast-count command to set the number of the LLDPDUs to be sent successively when a
new neighboring device is detected.
Use the undo lldp fast-count command to restore the default.
By default, the number is 3.
Examples
# Configure to send four LLDP successively when a new neighboring device is detected.
<Sysname> system-view
[Sysname] lldp fast-count 4
1-19