Display Transceiver Diagnosis Interface - 3Com 5500-EI PWR Reference Manual

Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port configuration
mismatch
Transceiver type not supported by port
hardware
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 1/0/25.
<Sysname> display transceiver alarm interface gigabitethernet 1/0/25
GigabitEthernet1/0/25 transceiver current alarm information:
TX fault
Table 3-6 Description on the fields of display transceiver alarm interface
transceiver current alarm information
TX fault

display transceiver diagnosis interface

Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the display transceiver diagnosis interface command to display the currently measured value of
digital diagnosis parameters of a single or all anti-spoofing transceivers customized by H3C.
Examples
# Display the currently measured value of digital diagnosis parameters of the anti-spoofing pluggable
optical transceiver customized by H3C on interface GigabitEthernet 1/0/25.
<Sysname> display transceiver diagnosis interface gigabitethernet 1/0/25
GigabitEthernet1/0/25 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C) Voltage(V)
36 3.31
Field
Field
Bias(mA) RX power(dBM)
6.13 -35.64
Remarks
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port configuration.
Transceiver type is not supported on the port.
Current alarm information of the transceiver
TX fault
TX power(dBM)
-5.19
3-9
Description