Disconnect; Display Ftp Source-Ip - 3Com 5500-EI PWR Reference Manual

-rwxrwxrwx 1 noone
-rwxrwxrwx 1 noone
226 Transfer complete.
FTP: 1025 byte(s) received in 0.019 second(s) 53.00K byte(s)/sec.
# Display information about file config.cfg and save the information to file temp1.
[ftp] dir config.cfg temp1
227 Entering Passive Mode (192,168,0,152,4,3).
125 ASCII mode data connection already open, transfer starting for config.cfg.
.....226 Transfer complete.
FTP: 67 byte(s) received in 5.818 second(s) 11.00 byte(s)/sec.

disconnect

Syntax
disconnect
View
FTP client view
Parameters
None
Description
Use the disconnect command to terminate an FTP connection without quitting FTP client view.
This command has the same effect as that of the close command.
Examples
# Terminate the FTP connection without quitting FTP client view.
[ftp] disconnect
221 Server closing.
[ftp]

display ftp source-ip

Syntax
display ftp source-ip
View
Any view
Parameters
None
Description
Use the display ftp source-ip command to display the source IP address that the current device
serving as an FTP client uses every time it connects to an FTP server. If a source IP address is
nogroup 5286666 Oct 18
nogroup 306 May 13 11:17 swithc001
1-12
2006 switch5.bin