Info-Center Loghost - 3Com 5500-EI PWR Reference Manual

Related commands: info-center enable, display info-center.
Examples
# Configure the system to output information to the log buffer with the size of 50.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center logbuffer size 50

info-center loghost

Syntax
info-center loghost host-ip-addr [ channel { channel-number | channel-name } | facility
local-number ]*
undo info-center loghost host-ip-addr
View
System view
Parameters
host-ip-addr: IP address of a log host.
channel: Sets the information channel for the log host.
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the
system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
facility local-number: The logging facility of the log host. The local-number argument ranges from
local0 to local7, with the corresponding value ranging from 16 to 23. The default logging facility is local7,
with the value being 23.
Description
Use the info-center loghost command to enable information output to a log host through specifying
the IP address of the log host.
Use the undo info-center loghost command to disable information output to the log host.
By default, the switch does not output information to the log host. When it is enabled, the default
channel name will be loghost and the default channel number will be 2.
This command works only when the information center is enabled.
Be sure to set the correct IP address in the info-center loghost command. A loopback IP address will
cause an error message, prompting that the address is invalid.
Related commands: info-center enable, display info-center.
1-9